D3 Monster Horsepower Series

The "D3" (Duo3) is a new pro brushless racing motor designed for 2 & 4wd, 1/12th & 1/10th on-road, oval and off-road.

• New stronger gauss neo magnet rotor for more low end torque.
• New stator laminations wound with higher temperature wire for greater reliability.
• Faster switching sensor board design for greater response.
• Fully adjustable timing.
• Heavy duty low drag ball bearings.
• 1-4 cell Li-Po use with correct gearing.
  Over gearing can hurt your motor by causing the stator winds to over heat, melt the insulation and short out. To prevent this when trying new gearing or figuring out the best gearing for your vehicle, run for one minute and check the motor heat. You want to be under 165 degrees F.

All Trinity brushless motors are guaranteed to be free from defects at the time of purchase. Because of the nature of this product and the variables of gearing and battery voltage available there is no warranty for stators that failed due to over gearing or too much voltage input or a combination of the both.

The rotors are designed to withstand a certain rpm. This will never be exceeded in normal usage in a vehicle under load with the tires on the track. Rotor failures (shattered magnets) occurs when the motor is free revved either on the bench or by lifting the car up off the track and flooring the speed control. Rotors damaged by over revving is not covered under warranty.